Tripp-lite 93-2120_ES Manuale Utente Scaricare il pdf

Owner’s Manual

PDU Rackmount Power Strips

Designed for Mounting in 19 in. Racks

IMPORTANT SAFETY INSTRUCTIONS. This manual contains information

concerning the proper installation and use of Tripp Lite’s Rackmount Power Strips.

SAVE THESE INSTRUCTIONS.

Do not connect your power strip to an ungrounded outlet. Do not use it with extension cords

or adapters that eliminate its connection to ground. Your power strip is designed for indoor

use only. Install it away from heat emitting devices such as radiators and heat registers. Do

not install where excessive moisture or other conductive contaminants are present. Never

install electrical wiring during a lightning storm.

The power requirement of each device connected to an outlet of your power strip must not

exceed the Outlet Power Rating of your power strip (see Specifications). The total power

requirements of all devices connected to your power strip must not exceed the Maximum

Load Rating of your power strip (see Specifications).

Español: p. 3 • Français: p. 5

1U Rackmount Installation

To Mount Unit in Rack: Put four user-supplied rackmount

screws (A) through the unit’s mounting ears (B) and into the

rack rails as shown. The user must determine the fitness of the

rackmount screws to hold the unit in the rack before

installation.

0U Rackmount Installation

1. Reorient Mounting Ears: Unscrew the screws (A) holding

the unit’s mounting ears (B) to the sides of the unit. Use

the screws from Step 1 (A) to reattach the mounting ears

(B) to the unit as shown. Use only the manufacturer-

supplied screws or their equivalent (#6-32, ¼" flat head)

to reattach the mounting ears.

2. Mount Unit on Outside of Rack Rails: Put four user-

supplied screws (C) or similar mounting hardware

through the unit’s mounting ears (B) and into the side of

the rack as shown. The user must determine the fitness of

the user-supplied mounting hardware to support the unit

before mounting.

Wallmount/Under Counter Installation

Reorient the unit’s mounting ears as per the 0U Rackmount

Installation above, then put four user-supplied screws or

similar mounting hardware through the unit’s mounting ears

and into the mounting surface. The user must determine the

fitness of the user-supplied mounting hardware to support

the unit before mounting.

1U Rackmount Installation

0U Rackmount Installation

200303057 93-2120 PDU Owner’s Manual.qxd 4/16/2003 10:06 AM Page 1

1 2 3

Sommario

Pagina 1 - Owner’s Manual

Owner’s ManualPDU Rackmount Power Strips Designed for Mounting in 19 in. RacksIMPORTANT SAFETY INSTRUCTIONS. This manual contains information concerni

Pagina 2 - Manual del usuario

Manual del usuarioRegletas de contacto para montaje en bastidordel modelo PDUDiseñado para montaje en bastidores de 19 pulg.IMPORTANTES INSTRUCCIONES

Pagina 3 - 200303057 93-2120_ES

1111 W. 35th Street, Chicago, IL 60609 USA 773.869.1234 (USA) • 773.869.1212 (International) www.tripplite.com200303057 93-2120_ES

Commenti su questo manuale

Nessun commento

Tripp-lite 93-2120_ES Manuale Utente

Navigare online o scaricare Manuale Utente per Attrezzi Tripp-lite 93-2120_ES. Tripp Lite 93-2120_ES User Manual Manuale Utente

Sommario

Commenti su questo manuale

Prodotti e manuali riguardandi Attrezzi Tripp-lite 93-2120_ES